I had previously used a two cavity mold for bullets for a 6X45 bolt action, It was so accurate and such a pleasure to shoot that I was spending too much time casting. Their new 5 cavity mold helps resolve part of the problem. The bullet is extremely accurate and is easy to cast. Using a hot plate to bring mold up to temperature, the first bullets cast are usually keepers. It is the most accurate PCed bullet I have found.

Cast a couple of hundred bullets with new Arsenal mold I received today. Bullets dropped well from the mold with only a very light bump to the handles, Much better than any I have cast before. Bullets are designed for PC and accuracy. PC-ing starts tomorrow (drying tonight after being water dropped this afternoon). Load workup will be later this week. The bullet just looks like it will be super accurate. Can’t wait to test for accuracy. Best looking 6 mm design I have seen.

- Tried the noted mold at range and it gave better than MOA with starting charge of two powders tested. It is outstanding in 6X45. Thanks for the design!

-- Attached is a “3” shot group shot in a 6x45 with an Apache Gunworks barrel that crooned at 2485 fps. Target was at 100 yds.